If you want to erase all the users information and access records stored in the iGuard internal memory, and to reset all the settings to the factory defaults, you can perform the System Reset function to clear all the stored data. There are two databases inside the iGuard: User Database & Access Database. The User Database stores the user information, including the fingerprint data & the access rights. It also stores the department information. The Access Database only stores the Access records. It does not contain any user information.
You can selectively delete any one or both databases. It is done by selecting “Function 7" in the setup menu, as shown in the following:
|
Description |
LCD Display |
|
While in Standby Mode, press the Func key to enter the Setup Menu. You will be prompted to enter the Administrator Password (default: 123) as shown. |
Enter Password: _ |
|
Press the Func key to continue, then select Function 7 to enter the System Shutdown/Reset menu. |
Press 7: System Shutdown/Reset |
|
You will be asked if you want to delete the User Database. Enter 1 if you want to clear all the existing User Information, or else press 2 to keep the existing information. |
Reset User Dbase Yes/No (1/2)? _ |
|
Then, you will be asked if you want to delete the Access Database. Enter 1 if you want to clear the log, and enter 2 if you want to keep it. |
Reset Access log Yes/No (1/2)? _ |
|
Finally, you will then be asked if you want to reset the settings to the factory default. Enter 1 if you want to reset the device to its factory default (such as resetting the IP address to the default 192.168.0.200). |
Factory Default Yes/No (1/2)? _ |
|
The system will perform a system reset, and then it will return to the standby mode (it usually takes around 20 seconds). |
Mon 30 Dec 13:49 ID #:_ |
Note:
In the unlikely event that your iGuard does not function properly for some unknown reasons, you may also want to use this System Shutdown/Reset function to reset all the existing records in the machine.